Retain the SSD and mounting screw for installation onto the new boot device carrier.
14. If you are removing the second boot device carrier, repeat steps 3 and 4 on the lower boot device carrier slot.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a Removing and replacing a boot deviceboot device drive with the security cover installed drive with the security cover installed
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
Phillips No. 1 screwdriver
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
