HPE ProLiant DL320 Gen11 - Removing and Replacing the Access Panel

2. Press the bezel release latch (callout 1), and then pivot the bezel open (callout 2).
3. Release the right side of the bezel from the front panel (callout 3).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the access panelRemoving and replacing the access panel
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 59