HPE ProLiant DL320 Gen11 - Removing and Replacing a DIMM Guard

2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Remove the DIMM.
a. Open the DIMM slot latches (callout 1).
b. Lift the DIMM out of the slot (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a DIMM guardRemoving and replacing a DIMM guard
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 86