Installing the system board assemblyInstalling the system board assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
T-30 Torx screwdriver
Hex screwdriver—This tool is required if the serial port cable is to be installed.
Thermal grease
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Install the new system board assembly:
a. Slide the system board into the base pan (callout 1).
b. Tighten the thumbscrew (callout 2).
To Next Page
Loading...
