ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an internal USB deviceRemoving and replacing an internal USB device
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Unplug the USB device from the USB port.
To Next Page
Loading...
