8. Locate slot 3, and then remove the expansion slot blank.
9.
Install the 12G SAS expander card.
IMPORTANT: The 12G SAS expander card requires a controller. The server supports embedded, type-a, and
type-p Smart Array controllers. If using a type-p Smart Array controller, then install the controller in slot 1.
10.
Using the labels on each cable, connect the cables to the SAS expander.
For drive numbering, see "
Drive bay numbering: SAS expander".
11.
Install the riser cage.
12.
Connect cables from the 12G SAS expander to the controller.
13. Connect cables from the 12G SAS expander to the drive backplanes.
A standard configuration is shown. For additional cabling diagrams, see "Cabling".
Hardware options installation
120
To Next Page
Loading...
