Cabling
HPE ProLiant Gen10 DL Servers Storage Cabling Guidelines
When installing cables, observe the following:
• All ports are labeled:
◦ System board ports
◦ Controller ports
◦ 12G SAS Expander ports
• Most data cables have labels near each connector with destination port information.
• Some data cables are pre-bent. Do not unbend or manipulate the cables.
• Before connecting a cable to a port, lay the cable in place to verify the length of the cable.
• When routing cables from the front to the rear of the server, use the cable channels on either side of the chassis.
Cabling diagrams
Use the following tables to find cabling information and diagrams. For additional cabling configurations, see the Hewlett
Packard Enterprise website (
https://www.hpe.com/info/CablingMatrixGen10).
Table 3: SAS/SATA kits
Option kit
Cable part number From To Power cable part
number
Front 2 SFF SATA side by side (LFF) 882066-001
1
Drive backplane System board 869810-001
7
Front 2 SFF SAS/SATA drive cage (SFF) 869826-001
2
Drive backplane • SAS
expander
• Controller
869810-001
7
869825-001
7
Front 2 SFF SAS/SATA 1U drive cage
(LFF)
869826-001
2
Drive backplane • SAS
expander
• Controller
869810-001
7
Front/rear 2 SFF 2Premium SAS (SFF +
LFF)
P00698-001
1
Drive backplane System board 869810-001
7
Front 4 LFF SAS/SATA drive cages 869827-001
2
Drive backplane • SAS
expander
• Controller
869825-001
7
Table Continued
Cabling 144
To Next Page
Loading...
