HPE ProLiant DL385 - Installing a Flexiblelom Adapter

NOTE: Image may dier from actual product.
14. Install the access panel.
15.
Slide the server into the rack.
16.
Connect each power cord to the server.
17.
Connect each power cord to the power source.
18.
Power up the server.
The installation is complete.
Installing a FlexibleLOM adapter
Prerequisites
• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Power down the server.
2. Do one of the following:
• Disconnect each power cord from the power source.
• Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
Hardware options installation
130