CAUTION: When routing cables, make sure that the cables are not in a position where they can be pinched or
crimped.
9.
Route the SID cable through the opening in the front of the server, and then install the SID module. Secure the
module using the T-10 screw removed in step 8.
10. Connect the SID module cable to the power switch/SID module connector.
11. Install the fan cage.
12. Do one of the following:
•
Install the air bale.
• Perform steps 9–13 of “Installing a midplane 4LFF SAS/SATA drive cage”.
13.
Install the access panel.
14. Slide the server into the rack.
Hardware options installation
133
To Next Page
Loading...
