1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack.
5. Remove the access panel .
6. Remove the system air baffle.
7. If you are installing the expansion card in the slot 1, remove the existing rise cage .
8. Install the expansion card:
a. Open the riser slot retainer.
Retain the screw. This screw will be used to install the expansion card.
To Next Page
Loading...
