Position the tower server for hardware configurationPosition the tower server for hardware configuration
Remove the access panelRemove the access panel
Remove the system air baffleRemove the system air baffle
Remove the riser cageRemove the riser cage
Install the system air baffleInstall the system air baffle
Install the access panelInstall the access panel
Position the tower server for operationPosition the tower server for operation
Install the front bezelInstall the front bezel
Install the server into the rackInstall the server into the rack
Power up the serverPower up the server
Power down the serverPower down the server
Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical server data and programs .
IMPORTANT:IMPORTANT:
When the server is in standby mode, auxiliary power is still being provided to the system.
To power down the server, use one of the following methods:
Press and release the Power On/Standby button.
This method activates a controlled shutdown of applications and the OS before the server enters standby mode. It can also activate a
shutdown behavior governed by an OS configuration or policy.
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO 6.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.
Extend the server from the rackExtend the server from the rack
PrerequisitesPrerequisites
Before you perform this procedure, review the Rack warnings and cautions.
ProcedureProcedure
Slide the server tray out of the rack:
1. Loosen the server tray thumbscrews.
2. Grasp the tray notch and slide the server out of the rack.
To Next Page
Loading...
