The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 260 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT:IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor pack
will only support one device.
The capacitor pack is fully charged after the system boots.
SubtopicsSubtopics
Minimum firmware versionsMinimum firmware versions
Minimum firmware versionsMinimum firmware versions
ProductProduct Minimum firmware versionMinimum firmware version
Server system ROM 1.30
HPE MR type-o and type-p Gen11 controllers 52.22.3-4650
HPE SR900 series type-p Gen11 controllers 03.01.14.062
Energy pack specificationsEnergy pack specifications
FeatureFeature DescriptionDescription
Time required to recharge Smart Storage Battery 12 W: 1 hour (For maximum load of 3 devices)
Duration of Smart Storage Battery backup 150 seconds (maximum support)
The Smart Storage Battery provides a sufficient duration to transfer
the cached data from DDR memory to flash memory, where the data
remains indefinitely or until a controller retrieves the data.
For more information, see the QuickSpecs documentQuickSpecs document for the Smart Storage Battery.
Installing an energy packInstalling an energy pack
PrerequisitesPrerequisites
Make sure that the following components are installed:
Compatible storage controller
Storage controller backup power cable
If you are installing the HPE Smart Storage Hybrid Capacitor, verify that the system meets the minimum firmware requirements .
About this taskAbout this task
To Next Page
Loading...
