19. Connect all peripheral cables to the server.
20. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
21. Power up the server.
22. Update the server and controller firmware if they are not the latest revision .
23. Configure the controller .
ResultsResults
The installation is complete.
Energy pack optionsEnergy pack options
If there is an unplanned server power outage, the flash-backed write cache (FBWC) feature of HPE storage controllers requires a centralized
backup power source to back up the write cache data in a flash device. This server supports the following power options—collectively
known as energy pack:
HPE Smart Storage Battery
HPE Smart Storage Hybrid Capacitor
One energy pack supports multiple devices. After it is installed, the status of the energy pack appears in HPE iLO. For more information, see
the iLO user guide:
https://www.hpe.com/support/ilo6https://www.hpe.com/support/ilo6
SubtopicsSubtopics
HPE Smart Storage BatteryHPE Smart Storage Battery
HPE Smart Storage Hybrid CapacitorHPE Smart Storage Hybrid Capacitor
Energy pack specificationsEnergy pack specifications
Installing an energy packInstalling an energy pack
HPEHPE Smart Storage Battery Smart Storage Battery
The HPE Smart Storage Battery supports both HPE SR and MR storage controllers.
A single 96 W battery can support up to 24 devices.
After the battery is installed, it might take up to two hours to charge. Controller features requiring backup power are not re-enabled until
the battery is capable of supporting the backup power.
This server supports the 96 W HPE Smart Storage Battery with the 260 mm cable.
HPEHPE Smart Storage Hybrid Capacitor Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports both HPE SR and MR storage controllers.
To Next Page
Loading...
