a. Connect each power cord to the server.
b. Connect each power cord to the power source.
19. Power up the server.
ResultsResults
The installation is complete.
Optical drive optionOptical drive option
Install a slim-type SATA optical drive to read/write data on optical discs.
SubtopicsSubtopics
Installing the optical drive optionInstalling the optical drive option
Installing the optical drive optionInstalling the optical drive option
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
Optical drive cable option (756914-001)
T-15 Torx screwdriver
Phillips No. 1 screwdriver
Spudger or any small prying tool
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. If installed, remove the front bezel .
6. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack.
To Next Page
Loading...
