Remotely: Connect to the iLO web interface and run a remote console:
a. Verify the following:
iLO is licensed to use the remote console feature.
If the iLO is not licensed, visit the HPE website:
https://www.hpe.com/info/ilohttps://www.hpe.com/info/ilo
The iLO dedicated network port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
Note the following:
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
c. Enter the iLO login name and password, and then click Log In.
d. In the navigation tree, click the Remote Console & Media link, and then launch a remote console.
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
6. Configure the initial server setup.
7. Set up the storage .
8. Deploy an OS or virtualization software.
9. After the OS is installed, update the drivers.
Operational requirementsOperational requirements
When preparing the site and planning the installation for the HPE ProLiant ML110 Gen11 Server, be sure to observe the following general
operational requirements:
Space and airflow requirements
Temperature requirements
Power requirements
Electrical grounding requirements
For server-specific environmental requirements, see Environmental specifications.
SubtopicsSubtopics
Space and airflow requirementsSpace and airflow requirements
Temperature requirementsTemperature requirements
Power requirementsPower requirements
Electrical grounding requirementsElectrical grounding requirements
Space and airflow requirementsSpace and airflow requirements
To Next Page
Loading...
