ResultsResults
The installation is complete.
CablingCabling
This chapter includes cabling guidelines and diagrams for internal component cabling.
SubtopicsSubtopics
Cabling guidelinesCabling guidelines
Cabling diagramsCabling diagrams
Internal cabling managementInternal cabling management
Storage cablingStorage cabling
Internal USB RDX docking station cablingInternal USB RDX docking station cabling
Riser board cablingRiser board cabling
HPE NS204i-u Boot Device cablingHPE NS204i-u Boot Device cabling
Fan cablingFan cabling
Optical drive SATA-power cablingOptical drive SATA-power cabling
Chassis intrusion detection switch cablingChassis intrusion detection switch cabling
Serial port cablingSerial port cabling
VGA cablingVGA cabling
Front I/O module cablingFront I/O module cabling
Cabling guidelinesCabling guidelines
Observe the following:
Some diagrams show alphabetical callouts A, B, C, etc. These callouts correspond to labels near the connectors on the cable.
The cable colors in the cabling diagrams used in this chapter are for illustration purposes only.
Observe all guidelines when working with server cables.
Before connecting cablesBefore connecting cables
Note the port labels on the PCA components. Not all these components are used by all servers:
System board ports
Drive and power supply backplane ports
Expansion board ports (controllers, adapters, expanders, risers, and similar boards)
Note the label near each cable connector. This label indicates the destination port for the cable connector.
Some data cables are prebent. Do not unbend or manipulate the cables.
To prevent mechanical damage or depositing oil that is present on your hands, and other contamination, do not touch the ends of the
connectors.
To Next Page
Loading...
