Orient the server back to tower mode.
Install the server into the rack.
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server.
ResultsResults
The installation is complete.
Accelerator optionsAccelerator options
This server supports various accelerator options to meet your computational and graphics workload requirements. For a list of supported
accelerator models, see the server QuickSpecs on the Hewlett Packard Enterprise website (https://buy.hpe.com/us/en/p/1014705725https://buy.hpe.com/us/en/p/1014705725).
PCIe workload accelerators—These options are PCIe card–based, direct–attach solutions that use solid–state storage technology
directly on the PCI bus to boost I/O performance and reduce latency to scale in line with your processing requirements.
Computational and graphics accelerators—These options deliver accelerated compute performance for a range of deep learning, high–
performance computing (HPC), and graphics–intensive applications.
SubtopicsSubtopics
Accelerator installation guidelinesAccelerator installation guidelines
Installing an accelerator option in the riser cageInstalling an accelerator option in the riser cage
Accelerator installation guidelinesAccelerator installation guidelines
This server does not support the installation of different accelerator models in the same system.
To maintain proper system cooling, the redundant fan option kit is required for accelerator installation.
If an NVIDIA L4 Tensor Core graphic accelerator is installed, observe the following:
Processor with TDP equal or less than 150 W.
Accelerator support option kit (P66618-B21) is installed.
The limited operating inlet ambient temperatures required for accelerators vary based on the model and the server drive configuration.
For more information, see the server QuickSpecs on the Hewlett Packard Enterprise website
(https://buy.hpe.com/us/en/p/1014705725https://buy.hpe.com/us/en/p/1014705725).
IMPORTANT:IMPORTANT: Workloads for high performance accelerators with passive cooling can cause the fans to operate at high
speeds to maintain optimum system cooling. Hewlett Packard Enterprise does not recommend installing accelerators with
passive cooling in or near a site where there is a reasonable expectation for a quiet environment.
Installing an accelerator option in the riser cageInstalling an accelerator option in the riser cage
To Next Page
Loading...
