ItemItem DescriptionDescription
1 HPE NS204i-u Boot Device slot 1
2 HPE NS204i-u Boot Device slot 2
3 Padlock eye
4 Kensington slot
5 Slot 4 PCIe5 x16 (16, 8, 4)
6 Slot 3 PCIe5 x16 (16, 8, 4)
7 Slot 2 PCIe5 x16 (16, 8, 4)
8 Slot 1 PCIe5 x16 (16, 8, 4)
9 Flexible Slot power supply 1
10 Flexible Slot power supply 2
11 Slot 14 OCP PCIe5 x16
12 Serial port
13 VGA port
14 USB 3.2 Gen1 ports
15 iLO dedicated network port
16 NIC port 2
17 NIC 1 / iLO shared port (1 GbE)
Optional
SubtopicsSubtopics
Display device setupDisplay device setup
Display device setupDisplay device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible PCIe5 graphics card that supports this feature in the slots 2 and 3.
Rear panel LEDsRear panel LEDs
1
1
1
1
1
1
1
To Next Page
Loading...
