a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack.
5. Remove the access panel .
6. Remove the system air baffle.
7. If installed, remove the riser cage.
8. If installed, remove the full-height full-length expansion card from the PCIe slot 1, do the following:
a. Open the riser slot retainer.
To Next Page
Loading...
