Install the Install the serverserver into the into the rackrack
PrerequisitesPrerequisites
Get help to lift and stabilize the server during rack installation. If the If the serverserver is installed higher than chest level, an additional person is installed higher than chest level, an additional person
might be required to help install the might be required to help install the serverserver:: One person to support the server weight, and the other to slide the server into the rack.
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
A fully populated server is heavy. Hewlett Packard Enterprise recommends removing the external chassis components before removing
the server from the rack.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Grasp the tray notch to slide the tray out of the rack.
2. Place the server on the tray.
Verify that the front panel of the server is aligned with the front of the tray.
To Next Page
Loading...
