HPE SN6500B

LED name LED color Status of hardware Recommended action
Steady green DC output is within the expected
range.
No action is required.
Fan assembly
status (one
bicolor LED)
No light Fan assembly is not receiving
power.
Verify that the fan FRU is seated
correctly.
Steady green Fan assembly is operating
normally.
No action is required.
Steady amber
(for more than
5 seconds)
Fan fault for one of the following
reasons:
• A fan assembly with
mismatched airflow is
present.
• One or more of the fans in
the fan assembly has failed.
Try one of the following:
• Replace the mismatched fan
assembly with one that has the
correct airflow direction.
• Replace the faulty fan assembly.
Table 9: LED patterns on the port side of the HPE StoreFabric SN6500B, SN6000B,
SN3000B, and SN4000B 16Gb FC switches
LED name LED color Status of hardware Recommended action
System power
(green)
No light System is off or there is an
internal power supply failure.
Verify that the system is powered on
(power supply switches set to I), the
power cables are attached, and the
power source is live.
The unit may be faulty. Contact your
switch service provider.
Steady green System is on and power
supplies are functioning
properly.
No action is required.
System status
(bicolor)
No light System is off or there is no
power.
Verify that the system is on and has
completed booting.
Steady green System is on and is functioning
properly.
No action is required.
Steady amber
(for more than
5 seconds)
A system fault has occurred.
This LED is steady amber
during POST, which is normal
and does not indicate a fault.
Check the failure indicated on the
system console.
Contact your switch service provider.
Table Continued
Operating HPE 16Gb FC switches 57