MINIKEY User Manual Loading and printing
Page 16 of 66 HSA SYSTEMS
Functions while in print mode
Screen display
While in print mode, the screen will display a print performance screen, along with the
calculated ink level remaining.
From the top, the performance screen displays:
Speed
Measured (by encoder) or set speed, in m/min. Also displays the number of prints per
hour.
Lot
Number of prints done since print mode was last activated
Total
Number of prints in total for this job
Timer
How long time the print mode has been active
If a database is active, the current record number and time remaining of database
print is also displayed.
Cartridge maintenance
While in print mode, it is possible to perform certain cartridge functions.
Press [1] .. [4] to work with respective cartride. Notice only needed numbers are
defined – so as example, if only 2 cartridges are defined, keys 3 and 4 will do nothing.
In “ink management”, you can perform
Reset of ink level
On level bar, the ink level can be reset
Disconnect cartridge power
The MK does not have a switch. It is recommended to switch off power before
cartridge is taken out.
To Next Page
Loading...
Need help?
General
