NOTICE
Do not power on a router before you finish installing the router and connecting cables.
Tools and Accessories
l Wire stripper
l Flat-head screwdriver
l ESD wrist strap
l 3-pin terminal block
l Three cables (separately purchased)
Procedure
Step 1 Verify that the router is reliably grounded.
Step 2 Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact
with your wrist.
Step 3 Assemble the 3-pin Boolean output cables.
NOTE
The three cables are connected to the 3-pin terminal block in the same way. The following procedure
uses one cable as an example.
1. Use a wire stripper to peel about 7 mm length of insulation coating off one end of the
cable.
NOTICE
Do not cut the metal conductor of the cable when peeling insulation coating.
2. Insert the bare wire into a wire hole.
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
5 Installing an AR550 Series Industrial Switching Router
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
108
To Next Page
Loading...
