Huawei AR Series - 4.8.7 Connecting the 180 W PoE Midspan

1. Insert pins of the 2-pin terminal block to the DC power socket of the router, and then
tighten the slotted screws at both ends of the connector with a flat-head screwdriver.
2. Connect cables at the other end to an external DC power supply system.
CONSOLE
RESERVE FE0
RST
GE0
RX TX
GE1
MONITOR
RX TX
FE2 FE4
FE1 FE3 FE5
DC power supply system
3G
SIM1 SIM2
12 V; 6 A or
24 V; 3 A or
-48 V; 4 A
NEG(-) RTN(+)
12 V; 6 A or
24 V; 3 A or
-48 V; 4 A
NEG(-) RTN(+)
12 V; 6 A or
24 V; 3 A or
-48 V; 4 A
NEG(-) RTN(+)
----End
4.8.7 Connecting the 180 W PoE Midspan
Context
DANGER
To avoid electric shock, do not connect power cables while the power is on.
NOTICE
Do not power on a router before you finish installing the router and connecting cables.
Tools and Accessories
l Wire stripper
l Flat-head screwdriver
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
4 Installing an AR530 Series Industrial Switching Router
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
82