Huawei AR Series - Page 24

Tools and Accessories
l ESD wrist strap
l Phillips screwdriver
l M3 screw
l DIN rail
Procedure
Step 1 Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact
with your wrist.
Step 2 Mount the DIN mounting kit onto the rear panel of the router with M3 screws, and then use a
Phillips screwdriver to tighten the M3 screws.
Step 3 Place the rear panel of the router in front of the DIN rail and ensure that the DIN rail fits in
between the fixture near the top of the DIN mounting kit and the spring latch near the bottom.
Step 4 Make the router incline forward with the bottom away from the DIN rail, and place the fixture
at the rear of the DIN mounting kit on the top of the DIN rail.
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
3 Installing an AR500 Series Industrial Access Router
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16