Step 4 Place the rear panel of the router in front of the DIN rail and ensure that the DIN rail fits in
between the fixture near the top of the DIN mounting kit and the spring latch near the bottom.
Step 5 Make the router incline forward with the bottom away from the DIN rail, and place the fixture
at the rear of the DIN mounting kit on the top of the DIN rail.
Step 6 Slowly push the router toward the DIN rail to make the spring latch near the bottom of the
DIN mounting kit move down. The spring latch then bounces back to fix the router on the
DIN rail.
NOTE
If the spring latch is too tight to move down, you can pull down the spring latch during the installation.
Step 7 Move the left fixture to attach it to the router, and then use the Phillips screwdriver to tighten
the screws on the fixture.
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
3 Installing an AR500 Series Industrial Access Router
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19
To Next Page
Loading...
