HUAWEI B890 4G LTE Smart Hub
5.2 Configuring Wireless WAN Profile
This section describes how to add, edit, and delete a wireless WAN profile.
Context
To add a profile:
Procedure
Step 1 Choose Settings > Dial-up > Wireless WAN Profile.
Step 2 Click New Profile, set the profile-associated parameters.
Step 3 Enter User name and Password.
To obtain User name and Password, contact your service provider.
Step 4 Select a connection mode in Connection mode drop-down list.
Auto: The Smart Hub connects to the Internet automatically when powered on.
Once connected, the Smart Hub will not automatically disconnect from the
Internet.
Manual: The Smart Hub connects to the Internet after you click Connect from
the Connection page.
On demand: The Smart Hub automatically connects to the Internet when data
transmission exists. The Smart Hub disconnects from the Internet automatically
if the period during which no data is transmitted exceeds Max. idle time (s).If you
are charged according to the length of time you are connected to the Internet, it is
recommended that you select this mode.
Max. idle time (s): This specifies the longest idle period for the Internet connection. In Auto
mode, the Smart Hub disconnects from the Internet automatically if no data is transmitted
during this specified period.
Step 5 Click Save.
To edit a profile: from Profile name, select the profile to modify. Click Edit to modify the
WAN profile settings. And click Save.
To delete a profile: from Profile name, select the profile to delete. And click Delete.
----End
5.3 Configuring Wireline WAN Profile
You can edit the wireline WAN profile from this page.
Procedure
Step 1 Choose Settings > Dial-up > Wireline WAN Profile.
Step 2 From Profile name, select the profile to modify.
To Next Page
Loading...
Need help?
General
