Huawei B890

HUAWEI B890 4G LTE Smart Hub
Online Help
Issue 01 (2013-02-05)
32
10.4 Configuring IPv6 DHCP Server
Your device supports to automatically assign IPv6 address to the network devices.
Procedure
Step 1 Choose Settings > DHCP > IPv6 DHCP.
Step 2 Select Enable to enable the IPv6 DHCP server.
Step 3 Select one configure mode from the Configuration mode drop-down list box.

UseAllocatedSubnet: The devices will automatically get the IPv6 address
information (including IPv6 address, Prefix, Prefix Length, Preferred Life Time,
Valid Life Time) and DNS Server address from the device.

UseAllocateOther: The devices will automatically get the IPv6 address Prefix
and Prefix length from the router advertisement. And will auto get the DNS Server
address from the device.
Step 4 Click Apply.
----End
10.5 Configuring SLAAC
You can configure the Stateless Address Autoconfiguration (SLAAC) when IPv6
DHCP Server is enabled.
Procedure
Step 1 Choose Settings > DHCP > SLAAC.
Step 2 Select Enable to enable the SLAAC.
Step 3 Select configure mode from the Configuration mode drop-down list box.

UseAllocatedSubnet: The devices will auto get the IPv6 address Prefix and
Prefix length from the router advertisement.
Step 4 Click Apply.
----End
10.6 Configuring Static Address
You can assign a static IP address to a MAC address.
Procedure
Step 1 Choose Settings > DHCP > Static Address.
Step 2 Click Add, enter the MAC Address and IP Address, select the Status.
Step 3 Click OK to save the settings.