EasyManua.ls Logo

Huawei BTS3900C - Page 145

Huawei BTS3900C
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Trans
missi
on
Mode
Mode
Supp
orted
Application Scenario Legend
IP
Over
E1/T1
Comm
on
Trans
missio
n
GSM
+UMT
S
Scenario 1: The UTRP is not configured. The
transmission cable is connected to the E1/T1 port on
the WMPT or UMPT. The WMPT or UMPT is
interconnected to the GTMU using the electrical port
or optical port.
Scenario 2: The UTRP is configured. The transmission
cable is connected to the E1/T1 port on the UTRP. The
WMPT or UMPTis interconnected to the GTMU using
the electrical port or optical port.
"2" in the
Figure 7-7
shows the cable
connections in
scenario 1.
GSM
+LTE
The UTRP is configured. The transmission cable is
connected to the E1/T1 port on the UTRP. The
LMPT or UMPT is interconnected to the GTMU using
the electrical port or optical port.
"3" in Figure
7-7 shows the
cable
connections.
UMTS
+LTE
The UTRP is configured. The transmission cable is
connected to the E1/T1 port on the UTRP. The
LMPT or UMPT is interconnected to the WMPT or
UMPT using the electrical port or optical port.
"4" in the
Figure 7-7
shows the cable
connections.
IP over
FE/GE
Comm
on
Trans
missio
n
GSM
+UMT
S
Scenario 1: The UTRPc is configured. The
transmission cable is connected to the FE/GE optical
port or electrical port on the UTRPc.
Scenario 2: The UTRP2 is configured. The
transmission cable is connected to the FE/GE optical
port on the UTRP2. The GTMU is interconnected to
the UTRP using the optical port.
Scenario 3: The UTRP is not configured. The
transmission cable is connected to the FE/GE optical
port on the WMPT or UMPT. The WMPT or UMPT is
interconnected to the GTMU using the electrical port.
Scenario 4: The UTRP is not configured. The
transmission cable is connected to the FE/GE electrical
port on the WMPT or UMPT. The WMPT or UMPT is
interconnected to the GTMU using the optical port.
Scenario 5: The UTRP is not configured. The
transmission cable is connected to the FE/GE electrical
port or optical port on the WMPT or UMPT. The
WMPT or UMPT is interconnected to the GTMU
through the backplane.
"5" in the
Figure 7-7
shows the cable
connections in
scenario 1.
BTS3900C (Ver.C)
Hardware Description 7 BTS3900C Cables
Issue 03 (2013-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
136

Table of Contents

Other manuals for Huawei BTS3900C

Related product manuals