Huawei ePico3801 - Figure 2-4 Leds of the Epico3801; Table 2-2 Status of the Leds of the Epico3801

SN Port or Button Function
6 RST This button is used to reset the device. You can press
the RST button once to reset the ePico3801 or press
this button three times consecutively to restore the
factory settings of the ePico3801, such as the
password used to log in to the WebUI and the IP
address used for local maintenance of the ePico3801.
LEDs of the ePico3801
The ePico3801 has four LEDs, which show the running status of the ePico3801 through different
colors and blinking frequencies.
The four LEDs are located on the front panel of the ePico3801. After sliding open the cover in
the upper left corner of the front panel, you can see the four LEDs, as shown in Figure 2-4.
Figure 2-4 LEDs of the ePico3801
Table 2-2 describes the status of the LEDs of the ePico3801.
Table 2-2 Status of the LEDs of the ePico3801
LED
Function Color/Status Meaning
PWR This LED
indicates the
power status.
Off and green There is no power supply, or the
power supply is faulty.
On and green The power supply is normal.
2 Introduction to the ePico3801
ePico3801
User Guide
2-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009–09–23)