Context
When a UE without authorization attempts to access an ePico cell in close mode, the ePico cell
sends a rejection message to the UE. As a result, the UE fails to access the ePico cell. The reject
reason can be configured as required.
Procedure
Step 1 Log in to the APM. Choose Configuration > Single Configuration and select an ePico3801 to
be maintained. Then, click Configure to enter the configuration window.
Step 2 Choose Terminal Parameter > WIRELESS > Configuration > ACCESSREJECTOPT in
the navigation tree to configure the access reject reason.
NOTE
For details about how to set the parameters, see Help in the corresponding command window.
Step 3 After the parameter setting is complete, click Apply. A system message is displayed, indicating
whether the parameter setting is successful.
----End
5.6.4 Modifying the Location Indication Mode
This chapter describes how to configure the location indication mode on the AP Manager (APM)
so that the UEs can receive location messages after entering the ePico cell. The location
indication mode is classified into the PLMN location indication and the SMS location indication.
Context
The PLMN location indication or SMS location indication mode can be selected as required so
that the UEs can receive location messages after entering the ePico cell.
l PLMN location indication: When a UE enters an ePico cell, the ePico3801 sends a
customized message to the UE. After the UE associates the PLMN ID with the message
sent from the ePico3801, the customized message instead of the PLMN ID is displayed on
the UE. This indicates that the UE is in the coverage area of the ePico cell. After the UE
moves to a macro cell, the PLMN ID of the macro cell is displayed on the UE. This indicates
that the UE is in the coverage area of the macro cell.
l SMS location indication: When a UE enters an ePico cell, the ePico3801 sends an SMS
message to notify that the UE is in the coverage area of the ePico3801 cell.
NOTE
The contents of both the PLMN location indication and SMS location indication need to be set in the AHR
subscription information. For details, see the AHR Operator Guide.
If you select the SMS location indication, you need to enable the SMS location indication switch and set
the penalty time as required.
Procedure
Step 1 Log in to the APM. Choose Configuration > Single Configuration and select an ePico3801 to
be maintained. Then, click Configure to enter the configuration window.
Step 2 Choose Terminal Parameter > WIRELESS > Configuration >
LOCATIONINDSWITCH in the navigation tree to configure the location indication mode.
ePico3801
User Guide 5 Reconfiguring the ePico3801
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-15
To Next Page
Loading...
