Huawei ePico3801 - 5.6 Adjusting the ePico3801 Functions

5.6 Adjusting the ePico3801 Functions
This chapter describes how to adjust the application of the ePico3801 basic functions. The basic
functions consist of the HSPA status, emergency call redirection switch, permission reject
reason, location indication mode, differentiated billing mode, and location positioning mode.
5.6.1 Modifying the HSPA Status
This chapter describes how to modify the HSPA status of the ePico cell so that the HSPA function
can be activated or deactivated.
5.6.2 Configuring the Emergency Call Redirection Switch
This chapter describes how to configure the emergency call redirection switch on the AP
Manager (APM) so that the emergency calls can be made in other cells.
5.6.3 Modifying the Access Reject Reason
This chapter describes how to manually modify the UE access reject reason on the AP Manager
(APM). The reject reason can be configured as required.
5.6.4 Modifying the Location Indication Mode
This chapter describes how to configure the location indication mode on the AP Manager (APM)
so that the UEs can receive location messages after entering the ePico cell. The location
indication mode is classified into the PLMN location indication and the SMS location indication.
5.6.5 Setting the Differentiated Billing Parameters
This chapter describes how to set the differentiated billing parameters on the AP Manager
(APM).
5.6.6 Configuring the Locating Function
This chapter describes how to configure the ePico3801 locating function so that the UEs in the
coverage area of the ePico3801 can be accurately located.
5.6.1 Modifying the HSPA Status
This chapter describes how to modify the HSPA status of the ePico cell so that the HSPA function
can be activated or deactivated.
Prerequisite
l The parameters of the ePico zone have been set successfully.
l You have logged in to the AP Manager (APM). The login account belongs to the
Administrator or Operators group.
Procedure
Step 1 Log in to the APM. Choose Configuration > Single Configuration and select an ePico3801 to
be maintained. Then, click Configure to enter the configuration window.
Step 2 Choose Terminal Parameter > WIRELESS > Configuration in the navigation tree to set the
HSPA status parameters of the ePico3801.
1. Choose CELLHSUPASTATE to set the cell HSUPA active state.
2. Choose CELLHSDPASTATE to set the cell HSDPA active state.
ePico3801
User Guide 5 Reconfiguring the ePico3801
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-13