Huawei ePico3801 - 4.4 Checking the Software Version

If... Description Then...
The test result of APM
LINK is Invalid or
TimeOut
The
communication
between the
ePico3801 and the
APM fails.
l Ensure that the transmission between
the ePico and the firewall and
between the firewall and the APM is
normal.
l Ensure that the APM is installed with
the current version of the ePico3801.
l Ensure that the IPsec tunnel between
the ePico and the firewall is
established successfully.
4. Check the TSP Current State status.
If... Description Then...
The TSP State status is
TransOK
The network
transmission is
normal.
End the check.
The TSP Current
State status is NOK
The network
transmission is
faulty.
Rectify the fault according to the
displayed fault cause of TSP Current
State.
NOTE
If the fault persists, contact the Huawei technical support engineers.
----End
4.4 Checking the Software Version
This chapter describes how to check the software version of the ePico3801.
Prerequisite
l The network transmission between the ePico3801 and the AP Manager (APM) is normal.
l The ePico3801 hardware is normal.
l You have logged in to the WebUI through a computer.
Procedure
l Log in to the WebUI to check the software version of the equipment.
The software version is directly displayed in the upper right of the WebUI window.
l Log in to the APM to check the software version of the equipment.
Choose Configuration > Single Configuration. In the Terminal Search area, enter the
relevant information of the equipment, and then click Search. The query result is displayed
in the Terminal List area.
----End
ePico3801
User Guide 4 Commissioning the ePico3801
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-7