Huawei ePico3801 - Page 44

Step 2 3.1 Logging in to the ePico WebUI. In the Execute Trouble Diagnose window, select Transfer
Trouble Diagnose and select Show All Result. Then, click Start to start checking the
transmission status of the ePico3801.
Step 3 Check the statistical information SCTP State, SecGW LINK, APM LINK, and TSP Current
State and ensure that the transmission between the ePico3801 and the NEs is normal.
1. Check the SecGW LINK status.
If... Description Then...
The test results of SecGW
LINK are as follows:
4 packet(s) transmitted
4 packet(s) received
Percent 0.00 packet lost
round-trip min/avg/max =
1/3/10 ms
The network
transmission
between the
ePico3801 and the
SecGW is normal.
Go to Step 3.2.
The test result of SecGW
LINK is Invalid or TimeOut
The communication
between the
ePico3801 and the
SecGW fails.
l Check whether the IP address
of the firewall configured on
the ePico is correct.
l Check whether the firewall
works normally.
2. Check the SCTP State status.
If...
Description Then...
The SCTP State status
is OK
The SCTP link is
established.
Go to Step 3.3.
The SCTP State status
is NOK
The SCTP link is
not established.
The
communication
between the ePico
and AG fails.
Ensure that the IPsec tunnel between the
ePico3801 and the firewall is
established successfully.
3. Check the APM LINK status.
If...
Description Then...
The test results of APM
LINK are as follows:
4 packet(s) transmitted
4 packet(s) received
Percent 0.00 packet lost
round-trip min/avg/
max = 1/3/10 ms
The network
transmission
between the
ePico3801 and the
APM is normal.
Go to Step 3.4.
4 Commissioning the ePico3801
ePico3801
User Guide
4-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009–09–23)