Huawei ePico3801 - 4.2 Checking the Hardware Status

Figure 4-1 Commissioning procedures
Procedure
Step 1 4.2 Checking the Hardware Status.
Step 2 Check the network transmission status between the ePico3801 and the SeGW, AG, and APM.
For details, see 4.3 Checking the Network Transmission.
Step 3 4.4 Checking the Software Version.
Step 4 4.5 Checking the Running Status.
Step 5 Use the UEs to test the services provided by the ePico. For details, see 4.6 Testing Services.
----End
4.2 Checking the Hardware Status
This chapter describes how to check the status of the ePico3801 hardware.
Procedure
Step 1 Check the LEDs on the equipment.
If the LEDs on the ePico3801 are in the state described in Table 4-2, it indicates that the
equipment is functioning properly.
ePico3801
User Guide 4 Commissioning the ePico3801
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-3