Huawei ePico3801 - 4.3 Checking the Network Transmission

LED State Description Handling Method
AIR ON (red) There is no GPS signal. l Check the GPS antenna
connector. If the
connector is loose,
reinsert the connector and
fasten it.
l Change the position for
installing the GPS
antenna.
Blinking red
(ON for 1s and
OFF for 1s)
The signals of the ePico3801
are under slight interference.
The ePico3801 works
properly, but the
telecommunication quality
deteriorates.
l Eliminate the interference
source around the
equipment.
l Change the position for
installing the ePico3801.
Blinking red
(ON for 0.125s
and OFF for
0.125s)
The signals of the ePico3801
are under strong
interference. The ePico3801
cannot work properly.
LINK OFF (green) The Ethernet port is
connected improperly.
Check whether the Ethernet
ports on the ePico3801 and
the peer equipment are faulty
and whether the Ethernet
cable is available.
----End
4.3 Checking the Network Transmission
This chapter describes how to check the network transmission of the ePico3801 to ensure that
the ePico3801 communicates with other NEs properly.
Prerequisite
The ePico3801 hardware is checked and in normal status.
Procedure
Step 1 Check the RUN/ALM LED.
If the RUN/ALM LED Is...
Then...
Blinking green (ON for 1s and OFF for 1s) The network transmission is normal. End the
check.
Other status Go to Step 2.
ePico3801
User Guide 4 Commissioning the ePico3801
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-5