3 ePico3801 Initial Configuration
About This Chapter
This chapter describes how to perform initial configuration of the ePico3801 on the WebUI so
that users can perform the configuration of the ePico3801 according to the access and
authentication mode.
Prerequisite
The ePico3801 has been installed and powered on.
Context
The ePico3801 can access the network through the following authentication modes: PPPoE dial-
up, static IP address, and DHCP. For details, see 2.5.1 Access Networking Scenarios. By
default, the ePico3801 supports the DHCP authentication mode. The initial configuration is not
required. If you need to use the PPPoE dial-up or static IP authentication mode, initial
configuration is required.
3.1 Logging in to the ePico WebUI
This describes how to log in to the WebUI. For details about how to log in to the AP Manager,
see the AP Manager Operator Guide.
3.2 Configuring the ePico3801
This chapter describes how to configure the ePico3801 on the WebUI when the ePico3801
accesses the network through the PPPoE dial-up or static IP address authentication mode.
ePico3801
User Guide 3 ePico3801 Initial Configuration
Issue 01 (2009–09–23) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-1
To Next Page
Loading...
