Huawei FusionDC1000A - Power Module

SW Button
Table 6-16 SW button description
Function
Description
Operation Description Indicator Status
Wireless
network RF_Z
(802.15.4)
pairing
In non-wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to enter the
wireless network pairing mode.
The RF_Z indicator is
blinking at super
short intervals.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
The RF_Z indicator is
blinking at long
intervals.
Press and hold down the button for
more than 8s to 20s to clear
network parameters.
The RF_Z indicator is
blinking at super
short intervals.
Turning on
WLAN
Press the button for less than 3s to
turn on the WLAN service.
None
Restoring the
default IP
address, factory
settings, and
user information
Hold down for 1 minute None
6.2.3 Power Module
Indicator
Table 6-17 PSU indicator description
Indicator
Colo
r
Name Status Description
Gree
n
Power
indicator
Steady on The converter has a power
input.
O The converter has no power
input or is faulty.
Blinking at
long intervals
The converter is being queried
(the indicator blinks at 0.5 Hz,
on for 1s and then o for 1s).
FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario) 6 Management System
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 75