"pciehp.pciehp_force=1 pci=pcie_bus_perf" at the end of the sentence.
Do not add the content in a new line.
Figure 3-51 Configuring kernel parameters (1)
Figure 3-52 Configuring kernel parameters (2)
3) Save the file and restart the compute node.
4) Run the cat /proc/cmdline command. If the command output contains
"pciehp.pciehp_force=1 pci=pcie_bus_perf", the kernel is configured
successfully.
Figure 3-53 Checking the configuration
n If SUSE 12.2 is installed in UEFI:
1) Run the cat /proc/cmdline command. If the command output does not
contain "pciehp.pciehp_force=1 pci=pcie_bus_perf", you need to
configure kernel parameters.
Figure 3-54 Opening the configuration file
FusionServer Pro CH121 V5 Compute Node
User Guide
3 Basic Operations
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 67
To Next Page
Loading...
