Huawei LUNA2000-200KWH-2H1 - 9 Replacing a Light

9 Replacing a Light
Prerequisites
● Fault locating: If the power supply is normal but the light is
o, the light is
damaged.
● Tools: at-head or Phillips insulated torque screwdriver, cable cutter, insulation
tape
●
Power-o: Turn o the DC switch of the light in the ESS.
Procedure
Step 1 Remove the faulty light.
CA UTION
During replacement, do not touch the ends of the light with bare hands.
Otherwise, electric shocks may occur.
Step 2 Install a new light in the original position.
----End
Follow-up Procedure
Step 1 Turn on the DC switch of the light in the ESS.
Step 2 Check whether the lighting function is restored.
----End
LUNA2000-200KWH-2H1 Smart String ESS
Maintenance Manual 9 Replacing a Light
Issue 02 (2023-02-28) Copyright © Huawei Digital Power Technologies Co., Ltd. 105