Figure 17-2 Removing the door status sensor
Step 4 Remove the enclosure of the new sensor, and then remove the screws from the
alarm cables.
Step 5 Place the new door status sensor to the installation position and tighten the
screws.
Step 6 Connect the alarm cables in sequence and tighten the screws.
Step 7 Reinstall the enclosure of the door status sensor.
----End
Follow-up Procedure
Check that the door status alarm is cleared.
LUNA2000-200KWH-2H1 Smart String ESS
Maintenance Manual 17 Replacing a Door Status Sensor
Issue 02 (2023-02-28) Copyright © Huawei Digital Power Technologies Co., Ltd. 130
To Next Page
Loading...
