Huawei LUNA2000-200KWH-2H1 - Page 140

Table 19-1 DIP switch settings
Toggle
Switch 1
Toggle
Switch 2
Toggle
Switch 3
Toggle
Switch 4
Toggle
Switch 5
Toggle
Switch 6
1 2 3 ON ON ON
Step 2 Disconnect cables from the T/H sensor.
Step 3 Removing the faulty T/H sensor.
Step 4 Set the DIP switches for a new T/H sensor based on the recorded information.
Step 5 Install the new T/H sensor.
Step 6 Connect the cables.
Step 7 Check that no alarm is generated.
----End
LUNA2000-200KWH-2H1 Smart String ESS
Maintenance Manual 19 Replacing a T/H Sensor
Issue 02 (2023-02-28) Copyright © Huawei Digital Power Technologies Co., Ltd. 134