Huawei LUNA2000-200KWH-2H1 - Page 161

Paint Damage Tool and
Material
Procedure Description
Logo and pattern
damage
even. Paint
drops are
prohibited on
the coating.
The surface
should be
smooth.
5. Leave the
repainted area
for
approximately
30 minutes
before
performing any
further
operation.
If a logo or pattern is damaged,
provide the logo size and color
number. Seek help from a local
supplier of advertisement coatings to
formulate a repair solution based on
the logo size, color, and damage.
Dent 1. If a dent is less than or equal to
100 mm
2
in area and less than 3
mm in depth, ll the dent with
Poly-Putty base and then perform
the same operations as those for
processing deep scratches.
2. If a dent is greater than 100 mm
2
in
area or greater than 3 mm in
depth, ask the local supplier for an
appropriate repainting solution.
Procedure
Step 1 Gently polish damaged areas using ne sandpaper to remove smudges or rust.
Figure 27-1 Polishing a damaged area using sandpaper
Step 2 Dip a piece of cotton cloth into anhydrous alcohol and wipe the polished or
damaged area to remove the dirt and dust. Then wipe o the anhydrous alcohol
with a clean and dry cotton cloth
LUNA2000-200KWH-2H1 Smart String ESS
Maintenance Manual 27 FAQ
Issue 02 (2023-02-28) Copyright © Huawei Digital Power Technologies Co., Ltd. 155