Figure E-4 Polishing a damaged area using sandpaper
Step 2 Dip a piece of cotton cloth into anhydrous alcohol and wipe the polished or
damaged area to remove the dirt and dust. Then wipe o the anhydrous alcohol
with a clean and dry cotton cloth
Figure E-5 Wiping a polished or damaged area using anhydrous alcohol
Step 3 Paint zinc-rich primer on the damaged coat using a brush or paint sprayer.
● If the base material is exposed in the area to be repaired, apply epoxy zinc-rich
primer, wait until the paint has dried, and then apply acrylic acid top coat.
● Select epoxy zinc-rich primer or acrylic acid top coat with a color the same as
the surface coating color of the equipment.
Step 4 Apply paint evenly to the damaged area based on the damage degree of the paint
using an aerosol spray, brush, or paint sprayer until all damage traces are invisible.
● Ensure that the painting is thin, even, and smooth.
● In the case that an equipment pattern has dierent colors, to prevent
undamaged areas and those with dierent colors as the damaged area from
being contaminated during repainting, cover such areas using white paper and
adhesive tape before repairing paint.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual E How Do I Repair Paint Damage?
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 110
To Next Page
Loading...