Smart PCS provides self-protection in high-temperature environments. The
power of the Smart PCS may decrease as the ambient temperature increases.
● Do not install the equipment in an area with strong vibration, noise, or
electromagnetic interference. The equipment shall be installed in an
environment with a magnetic eld strength less than 4 Gauss. If the magnetic
eld strength is greater than or equal to 4 Gauss, the equipment may fail to
work properly. If the magnetic eld strength is high, for example, in a
smeltery, you are advised to use a gauss meter to measure the magnetic eld
strength of the equipment installation position when the smelting equipment
is running normally.
● You are advised to install the Smart PCS in a place with a sunshade or install
an awning for the Smart PCS in case of high temperature or direct sunlight. It
is recommended that the front of the Smart PCS face north if it is installed in
the northern hemisphere or face south if it is installed in the southern
hemisphere.
● Take waterproof and insulation measures for unused DC power cables to
avoid personal injury or property loss caused by accidental contact with high
voltage or other reasons.
● AC and DC power cables must be vertically routed into maintenance
compartments and wiring terminals to avoid damage caused by horizontal
stress on the terminals, which is not covered under the warranty.
● The Smart PCS is not intended for use in a residential environment, must not be directly
connected to a residential low-voltage power grid, and may cause radio interference, in
which case the user may be required to take additional mitigation measures against
electromagnetic interference.
● The Smart PCS shall be physically separated from residential environments or radio
receivers by distance greater than 30 m, and can be equipped with additional ltering if
necessary.
4.2.2 Mounting Structure Requirements
● The mounting structure for the device must be reproof. Do not install the
device on ammable building materials to avoid personal injury or property
loss caused by re or other reasons.
● In residential areas, do not install the device on gypsum boards or walls made
of similar materials with weak sound insulation performance to avoid
disturbing residents.
● Ensure that the installation surface is solid enough to bear the weight of the
Smart PCS (for details, see Figure 4-1) to avoid personal injury or property
loss caused by the collapse of the mounting structure or other reasons.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 28
To Next Page
Loading...