Step 6 Install the other Smart PCSs in the same way. For details, see the gure in Step 5.
Step 7 Install the connecting brackets delivered with the base support. The connecting
brackets need to be installed on both the DC and AC sides.
A maximum of six Smart PCSs can be installed on the base support. If there are less than
six Smart PCSs, install them from left to right. Otherwise, the Smart PCS connecting
brackets cannot be used.
Figure 4-16 Installing and securing connecting brackets
----End
4.7 Mounting the Smart PCS on a Rear Bracket
Mounting Bracket
Purchase the mounting bracket separately from the Company. M12 bolt
assemblies are delivered with the mounting bracket.
The mounting bracket of the Smart PCS has four groups of tapped holes, each
group containing four tapped holes. Mark any hole in each group based on site
requirements and mark four holes in total. The two round holes are
recommended.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 42
To Next Page
Loading...