Huawei LUNA2000-213KTL-H0 - Disposing of the Smart PCS

Step 5 The settings of Grid Parameters, Protection Parameters, Feature Parameters,
Power Adjustment, and Power Baseline of the new device must be synchronized
from other devices. This section uses Grid Parameters settings as an example to
describe how to synchronize data. The operations for setting other parameters are
similar.
Click Monitoring, select a running device, choose Running Param. > Grid
Parameters > All > Batch congurations, and click Conrm to synchronize data
to the new device.
Step 6 Click Monitoring.
1. Select the faulty Smart PCS, choose Running Param. > Adjustment, and
record the values of Adjust total energy yield and Calibration of total
power supply from grid.
2. Select the new device, choose Running Param. > Adjustment, and set Adjust
total energy yield and Calibration of total power supply from grid to be
the same as those of the original device.
Step 7 (Optional) If a third-party NMS that complies with the IEC 104 protocol is
connected, choose Settings > IEC104, and ensure that the teleindication,
telemetering, telecontrol, and teleadjust signal numbers of the new Smart PCS on
all tab pages under IEC104 are the same as those of the faulty Smart PCS.
Step 8 Delete the faulty Smart PCS.
Choose Maintenance > Connect Device, select the faulty Smart PCS, click
Remove Devices, and click Conrm.
Step 9 Choose Maintenance > Connect Device, select the Smart PCS, and click
to
send a startup command. After the Smart PCS is started, check that it is running
properly.
Step 10 (Optional) Log in to the PV plant management system, access the plant, choose
Device Management, select the faulty Smart PCS, click Delete, and click OK.
NO TE
● Perform this step if you purchase and use the PV plant management system.
● The software version corresponding to the user interface (UI) screenshot in this step is
iMaster NetEco V600R023C00SPC110. The UI may vary by software versions and the
screenshot is for reference only.
----End
8.6 Disposing of the Smart PCS
If the Smart PCS reaches the end of its service life, dispose of it according to local
regulations for the disposal of electrical equipment.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 8 Device Maintenance
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 90