● Do not install the Smart PCS in noise-sensitive areas (such as residential
areas, oce areas, and schools) to avoid complaints. If the preceding areas
are unavoidable, the distance between the installation position and noise-
sensitive areas must be greater than or equal to 40 m.
● If the equipment is installed in a place with abundant vegetation, in addition
to routine weeding, harden the ground underneath the equipment using
cement or gravel (the area shall be greater than or equal to 3 m x 2.5 m).
● If the Smart PCS is installed in public places (such as parking lots, stations,
and factories) other than working and living areas, install a protective net
outside the device and set up a safety warning sign to isolate the device. This
is to avoid personal injury or property loss caused by accidental contact by
non-professionals or other reasons during device operation.
● Do not install the Smart PCS in areas containing ammable materials (such
as sulfur, phosphorus, liqueed petroleum gas, marsh gas, our, and cotton)
to avoid personal injury or property loss caused by re or other reasons.
● Do not install the Smart PCS in areas containing explosives (such as blasting
agents, display shells, reworks, and recrackers) to avoid personal injury or
property loss caused by explosion or other reasons.
● Do not install the Smart PCS in areas with corrosive substances (such as
sulfuric acid, hydrochloric acid, nitric acid, hydrogen sulde, and chlorine) to
avoid Smart PCS failure caused by corrosion, which is not covered under the
warranty.
● The mounting structure for the Smart PCS must be reproof. Do not install
the Smart PCS on ammable building materials to avoid personal injury or
property loss caused by re or other reasons.
● The device may corrode if it is installed in a salt-aected area near the sea.
For such locations, select a Smart PCS model designed for use near the sea.
For details, contact the Company. A salt-aected area refers to the region
within 500 m of the coast or prone to sea breeze. Regions prone to sea breeze
vary with weather conditions (such as typhoons and monsoons) or terrains
(such as dams and hills).
● The DC power cable from each Smart PCS to the power distribution cabin of
the ESS shall be at least 5 m long. The AC power cable from each Smart PCS
to the AC combiner box or the LV panel of the transformer station shall be at
least 5 m long. The Smart PCS provides the self-protection function against
circulating current. As the length of the input and output power cables
decreases, circulating current protection may be triggered, causing power
derating.
● Do not install the Smart PCS in an easily accessible place, because the voltage
is high and its enclosure and heat sink are hot during device operation. This is
to avoid personal injury or property loss caused by accidental contact by non-
professionals or other reasons during device operation.
● The Smart PCS shall be installed in a well-ventilated environment to ensure
good heat dissipation. The Smart PCS provides self-protection in high-
temperature environments. If the Smart PCS is installed in a poorly ventilated
environment, the power of the Smart PCS may decrease as the ambient
temperature increases.
● If the Smart PCS is installed in an enclosed environment, a heat dissipation
device or ventilation device shall be installed. The indoor ambient
temperature must not be higher than the outdoor ambient temperature. The
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 27
To Next Page
Loading...