Huawei LUNA2000-213KTL-H0 - Page 24

NO TE
The grid-forming function of the Smart PCS is disabled by default. If the grid-forming
function is required, purchase the license and load the license by referring to License
Management in the SmartLogger3000 User Manual . Otherwise, the grid-forming function
cannot be used.
Grid forming is dierent from frequency adaptability specied in grid connection standards
(such as GB/T 34120-2023). For details about how to set grid forming/grid following
parameters, see the following table.
Parameter Description
Grid Code
Grid Code Set the grid code of the country or region where the devices are
used.
Basic parameters
Working
mode
● In the grid forming scenario, set this parameter to VSG.
● In the grid following scenario, set this parameter to PQ.
Microgrid
compatibility
Disable
Automatic
switching of
the working
mode
Disable
Power baseline
Charge/
discharge rate
Set the charge/discharge rate based on site requirements.
Active Power
Baseline (kW)
After the charge and discharge rate is set, the system
automatically calculates the recommended value.
Apparent
Power
Baseline
(kVA)
Same as above
Maximum
Overload
Active Power
(kW)
Same as above
Maximum
Overload
Apparent
Power (kVA)
Same as above
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 2 Product Description
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 17