Huawei LUNA2000-213KTL-H0 - Page 62

Figure 5-8 Opening the AC maintenance compartment door
Step 3 Remove a rubber ring based on the cable diameter range. Cut o the joints
between rubber rings using scissors and then remove the rubber ring. All rubber
rings are removed in the same way.
NO TE
● Remove a rubber ring strictly based on the cable diameter range and ensure that the
crimping module is not damaged. Otherwise, the IP rating of the device will be aected.
● If there is a gap between the cable and the rubber ring, prepare restop putty by
yourself and seal the gap. The restop putty shall not contain corrosive elements such
as sulfur and phosphorus. The holes and gaps shall be lled evenly and tightly.
Figure 5-9 Removing a rubber ring
Step 4 Connect the AC power cables to the terminal block and ensure that the cables are
securely connected.
NO TE
The cable colors shown in the gures are for reference only. Select an appropriate cable
according to the local standards.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 5 Cable Installation
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 55